Solar water heaters are very common in our lives, and now every household has installed solar water heaters. The impact of solar water heaters on our lives is also very large. Not only can we take a hot bath. And you can quickly use hot water in the cold winter. But many friends will encounter a problem when using solar water heaters, that is, how to use the solar water heater regulating valve.
Common problems of solar heater valve
1. The solenoid valve is blocked.
2. If there is no solenoid valve, the water supply valve is blocked.
3. Water pressure problem.
4. There is a leak in the main unit, and it flows out from the side.
5. The sensor is broken, and there is a problem with automatic water supply.
Inspection Method:
1. Observe the total water meter of the tap water when you are going to the water to see if it turns fast or slow, and whether it turns continuously.
2. Boil the water from the solar energy to the hot water side to see if there is water. The water output indicates that the solenoid valve is good, otherwise the solenoid valve is broken. If the speed of the water is different from the tap water, the solenoid valve is blocked.
How to use solar heater valve
1. When using the stepless control valve, first hold the shower nozzle in your hand, and rush toward the basin, bathtub or floor drain (not to the human body), first turn the handle of the stepless control valve to the hot water end and lift it, and shower Water flows out from the sprinkler. When you feel that hot water is flowing out of the shower, turn the handle to the cold water end until the desired temperature of water is adjusted. After taking a bath, turn the stepless regulating valve to the cold water end and press the handle. Can.
2. For solar water heaters equipped with an electric heater control system, the starting conditions of the electric heater need to be set. If it meets the conditions, it will start, and vice versa. When the weather is bad and the water temperature cannot meet the bathing requirements, start the heat-assisted system. Before starting the hot auxiliary system, first test whether the leakage protection plug function is normal: insert the leakage protection plug into the socket of the corresponding model, click the “reset” button, the indicator light is on, click the “test” button, the reset button jumps up, indicating The light is off, indicating that the leakage protection plug functions normally. After the test is normal, press the reset button, the indicator light turns red, indicating that heating starts. When the temperature reaches the set temperature, the indicator light of the leakage protection plug turns green and maintains a constant temperature.
3, open, flow adjustment. Turn on the two fine-tuning switches first, and lift the handle VI port to discharge water within the water temperature adjustment range used. The water output changes with the lifting angle of the handle. Use cold water, hot water, and adjust the temperature. Lift the handle, the VI port will flow out, and the water temperature can be adjusted by rotating the handle left and right. The handle is realized. When the handle is turned to the extreme position on the right side, it will completely balance the flow and pressure of the cold and hot water for the hot water. When in use, if the flow of one end of the cold and hot water is too large, and it is not easy to control the water temperature by relying on the handle alone, you can adjust the fine-tuning switches at the two ends of the cold and hot water (fine-tune the flow to a smaller value if the flow is too large;) to make the flow of cold and hot water Properly, to balance the flow and pressure of hot and cold water, and easily obtain the ideal water temperature. closure. When the handle is pressed to the lowest position, it closes.
Post time: Dec-13-2021
